Chapter 5: Display Panel Messages
Display Panel Messages
80 Scantron OpScan 4ES and iNSIGHT 4ES Scanners
form printed on a heavier paper stock than the last
form scanned.
To resolve this condition:
1. Remove all sheets from the transport bed.
CAUTION: When removing a sheet from the
transport bed, remove it by pulling it forward
or backward along the paper path. Do not pull
the sheet out sideways (i.e. away from the
guide rail) because you may damage the roll-
ers.
2. Place the removed sheets back in the input tray.
3. Adjust the paper guide.
Press Cont to resume scanning.
End of Batch
or
This message appears after you pressed End on the
control panel after a valid read.
This message is information only and requires no
action.
To Next Page
Loading...