Chapter 5: Display Panel Messages
Display Panel Messages
84 Scantron OpScan 4ES and iNSIGHT 4ES Scanners
scanner responds by stopping the sheets on the
transport bed.
To resolve this condition:
1. Remove all sheets from the transport bed.
CAUTION: When removing a sheet from the
transport bed, remove it by pulling it forward
or backward along the paper path. Do not pull
the sheet out sideways (i.e. away from the
guide rail) because you may damage the roll-
ers.
2. Place the removed sheets back in the input tray.
3. Adjust the paper guide.
Press START to resume scanning.
Press OFF to put the scanner into sleep mode.
Not Ready
This message means that the scanner is not ready to
scan sheets.
Press START to ready the scanner to accept
commands from the host computer’s software.
Press OFF to put the scanner into sleep mode.
To Next Page
