Chapter 5: Display Panel Messages
Display Panel Messages
Operator’s Guide 91
Sheet Did Not Leave Select Stacker
The scanner displays this message when a sheet jams.
This message is also displayed as a result of a dirty
sensor and/or dirty conditions surrounding the sensor
area.
NOTE: Repair a sheet if it is torn, or otherwise
damaged. If repair is not possible, copy the marks
from a damaged sheet onto a new sheet.
To resolve this condition:
1. Clear all sheets from the scanner and Select
Stacker transport bed.
2. Blow canned air (Scantron recommends a non-
condensing propellant) onto the select sensor and
surrounding area to remove paper dust and debris.
3. Place any sheet(s) not processed by the host
software back in the input tray.
Press START to continue scanning after taking
corrective action.
Press OFF to put the scanner in sleep mode.
To Next Page
Loading...