Scantron OpScan 4ES - Page 6

Preface
vi Scantron OpScan 4ES and iNSIGHT 4ES Scanners
Software References Your scanner can operate using any of the following
software applications.
• ScanTools Plus
®
• ScanTools Prisma
®
• A custom software application created using
ScanTools Plus Link SDK
• A custom application created using ScanTools
Prisma SDK
This manual uses the generic term “ScanTools” when
referring to whichever software option you are using
to operate your scanner.
Document
Organization
This manual is organized as follows:
• Chapter 1, “Scanner Basics”, provides an overview
of OpScan 4ES and iNSIGHT 4ES scanner
components, features, and system requirements,
as well as safety and environmental information.
• Chapter 2, “Setting Up Your Scanner” describes
how to set up your scanner, install the necessary
driver software, and connect to the host computer.
• Chapter 3, “Operating Your Scanner” explains how
to scan sheets with your scanner.
• Chapter 4, “Scanner Modes” describes the various
scanner modes, when best to use each, and how to
select them.
• Chapter 5, “Display Panel Messages” explains each
of the display panel messages that you might see
on the LCD (liquid crystal display) display panel.
• Chapter 6, “Using the Background Menu” provides
a flowchart of the background menu system, as
well as explanations of each function.
• Chapter 7, “ES/ScanMark Emulation” describes
how to use ES/ScanMark
TM
mode to emulate a
Scantron ES 2010, ES 2260, or ES 2800 scanner.
• Chapter 8, “Cleaning the Scanner” explains how to
clean the scanner.