202
Using the Configurator
To add a telephone/page selector
1. Select the annunciator or display adder that you want to add the telephone to.
2. Click Insert > Add Display Adder.
3. Select Telephone/Page Selector in the Select Adder Type pulldown menu.
4. Select the header (connector) in the Select Header pulldown menu.
5. Click Add.
6. Click Close.
The telephone/page selector has 24 switches, all of which are initially un-assigned. They can
be configured as Phone Select, Dig Msg or Page Select.
19.43.5 Correlating selector switches to remote telephones
The following constraints apply to correlations between telephones and switches.
• Each dual LED/Switch combination on a Selector can control and annunciate only one
telephone (conventional circuit or addressable module).
• If a switch on one CPU (Annunciator) is already controlling a telephone, then no other
switch on that same CPU can be associated with the same telephone. However, any
given telephone module can be controlled from a similar LED/Switch combination on
another CPU.
Typically, a bank of selectors on one Annunciator mirrors those on another. However, this is
not required. For example, the Selector Switches at the Main Panel could control all the phone
modules on a job, while each remote Annunciator controls only a sub-set.
To correlate a selector switch to a telephone
1. Select the addressable loop or audio controller phone list view containing the telephone.
2. Click Insert > Add Correlations.
3. Click a maximum of one switch from each CPU that you want to correlate with this
telephone.
4. Click Add.
If you had previously correlated one or more switches to this telephone module, then you will
not see any available switches from the same CPU as those existing correlations.
To correlate a phone module to a switch
1. Select the Selector Switch.
2. Click Insert > Add Correlations.
3. Click only one Phone Module. A switch cannot control more than one telephone.
4. Click Add.
If the phone you added was already correlated to another switch on the same CPU, you will
receive a message "A select switch already exists for control circuit number nnn. A circuit can
only be assigned to one Telephone Switch per CPU".
If you selected more than one Phone to add, or if you press add again, then you will receive
the error message “Cannot correlate a Phone Select switch to more than one phone module”.
To Next Page
Loading...
Need help?
General
