60
Walk Test
7.4 Configuring Walk Test Areas
Walk test areas are areas containing devices to be tested. Walk test areas let you test devices
in one area while leaving the other areas active. You create walk test areas in the
Configurator. In order to use the assisted walk test, the system must have walk test areas
configured.
To create a walk test area
1. In the Configurator, select Walk Test Areas in the Job Tree.
2. Right-click in the Details pane and select Add WalkTest Area.
Figure 45 Add WalkTest Area
3. Enter a name for the walk test area, for instance 1st Floor, and then click Add.
The walk test area appears in the Details pane.
Figure 46 New walk test area
To Next Page
Loading...
Need help?
General
