22
Working with the Fire Alarm Control Panel and the Configurator
5. Press ENTER to confirm.
The system changes the active job.
2.6.2 Changing the Active Job using the Configurator
You can change the active job using the Configurator.
To change the active job using the Configurator
1. In the Configurator, click Panel > Manage Jobs.
The Manage Jobs Configuration window appears.
2. Right-click the job you want to make active, and then click Activate Job.
3. Click Yes to confirm.
The system changes the active job.
4. Click OK to close the Manage Jobs Configuration window.
2.7 Deleting a Job
The FACP can hold three jobs in its memory. If there are already three jobs on the FACP and
you want to send a new job, you must delete one of the old jobs.
To delete a job
1. In the Configurator, click Panel > Manage Jobs.
The Manage Jobs Configuration window appears.
2. Select the checkbox of the job that you want to delete.
3. Click Delete Selected.
4. Click Yes to confirm.
The system deletes the job.
2.8 Getting Configuration Information
If you experience difficulty, it is helpful to have information about how the Fire Alarm Control
Panel is configured. You can get this information from the Configurator and from the Fire
Alarm Control Panel itself.
Note: This procedure changes the configuration for all the nodes that are currently
connected to the system.
Note: You cannot delete the active job. You must make another job active first.
To Next Page
Loading...
Need help?
General
