Segger J-Link - Page 120

120 CHAPTER 3 J-Link software and documentation package
J-Link / J-Trace (UM08001) ©
2004-2017 SEGGER Microcontroller GmbH & Co. KG
Example
jlinkgdbserver -log “C:\my path\to\file.log”
3.3.5.10 -logtofile
Description
Starts the GDB Server with the option to write the output into a log file.
If no file is given via -log, the log file will be created in the GDB Server application
directory.
Note: For the GUI version, this setting is persistent for following uses of GDB
Server until changed via -nologtofile or the GUI.
Syntax
-logtofile
Example
jlinkgdbserver -logtofile
jlinkgdbserver -logtofile -log “C:\my path\to\file.log”
3.3.5.11 -halt
Description
Halts the target after connecting to it on start of GDB Server.
For most IDEs this option is mandatory since they rely on the target to be halted
after connecting to GDB Server.
Note: For the GUI version, this setting is persistent for following uses of GDB
Server until changed via -nohalt or the GUI.
Syntax
-halt
Example
jlinkgdbserver -halt
3.3.5.12 -noir
Description
Do not initialize the CPU registers on startup.
Note: For the GUI version, this setting is persistent for following uses of GDB
Server until changed via -ir or the GUI.
Syntax
-noir
3.3.5.13 -nolocalhostonly
Description
Starts GDB Server with the option to allow remote connections (from outside local-
host).
Same as -localhostonly 0
Note: For the GUI version, this setting is persistent for following uses of GDB
Server until changed via command line option or the GUI.