Segger J-Link - Page 121

J-Link / J-Trace (UM08001) © 2004-2017 SEGGER Microcontroller GmbH & Co. KG
121
Syntax
-nolocalhostonly
3.3.5.14 -nologtofile
Description
Starts the GDB Server with the option to not write the output into a log file.
Note: For the GUI version, this setting is persistent for following uses of GDB
Server until changed via -nologtofile or the GUI.
Note: When this option is used after -log, no log file will be generated, when -log
is used after this option, a log file will be generated and this setting will be overrid-
den.
Syntax
-nologtofile
Example
jlinkgdbserver -nologtofile // Will not generate a log file
jlinkgdbserver -nologtofile -log “C:\pathto\file.log” // Will generate a log file
jlinkgdbserver -log “C:\pathto\file.log” -nologtofile // Will not generate a log file
3.3.5.15 -nohalt
Description
When connecting to the target after starting GDB Server, the target is not explicitly
halted and the CPU registers will not be inited.
After closing all GDB connections the target is started again and continues running.
Some IDEs rely on the target to be halted after connect. In this case do not use -
nohalt, but -halt.
Note: For the GUI version, this setting is persistent for following uses of GDB
Server until changed via -halt or the GUI.
Syntax
-nohalt
Example
jlinkgdbserver -nohalt
3.3.5.16 -nosilent
Description
Starts the GDB Server in non-silent mode. All log window messages will be shown.
Note: For the GUI version, this setting is persistent for following uses of GDB
Server until changed via command line option or the GUI.
Syntax
-nosilent
3.3.5.17 -nostayontop
Description
Starts the GDB Server in non-topmost mode. All windows can be placed above it.