252 CHAPTER 6 Flash download
J-Link / J-Trace (UM08001) ©
2004-2017 SEGGER Microcontroller GmbH & Co. KG
First, choose the device in the project settings if not already done. The device set-
tings can be found at Project->Options for Target->Device.
To enable the J-Link flash loader J-Link / J-Trace at Project->Options for Tar-
get->Utilities has to be selected. It is important that "Update Target before Debug-
ging" is unchecked since otherwise uVision tries to use its own flashloader.
To Next Page
Loading...
