96 CHAPTER 3 J-Link software and documentation package
J-Link / J-Trace (UM08001) ©
2004-2017 SEGGER Microcontroller GmbH & Co. KG
The screenshot below shows a debug session in IDE. For download and more infor-
mation about emIDE, please refer to http://emide.org.
Console
GDB can be used stand-alone as a console application.
To connect GDB to GDB Server enter target remote localhost:2331 into the run-
ning GDB. Within GDB all GDB commands and the remote monitor commands are
available. For more information about debugging with GDB refer to its online manual
available at http://sourceware.org/gdb/current/onlinedocs/gdb/.
A typical startup of a debugging session can be like:
To Next Page
Loading...
