Segger J-Link - Page 97

To Next Page

To Previous Page

(gdb) file C:/temp/Blinky.elf

Reading symbols from C:/temp/Blinky.elf...done.

(gdb) target remote localhost:2331

Remote debugging using localhost:2331

0x00000000 in ?? ()

(gdb) monitor reset

Resetting target

(gdb) load

Loading section .isr_vector, size 0x188 lma 0x8000000

Loading section .text, size 0x568 lma 0x8000188

Loading section .init_array, size 0x8 lma 0x80006f0

Loading section .fini_array, size 0x4 lma 0x80006f8

Loading section .data, size 0x428 lma 0x80006fc

Start address 0x8000485, load size 2852

Transfer rate: 146 KB/sec, 570 bytes/write.

(gdb) break main

Breakpoint 1 at 0x800037a: file Src\main.c, line 38.

(gdb) continue

Continuing.

Breakpoint 1, main () at Src\main.c:38

38 Cnt = 0;

(gdb)

Eclipse (CDT)

Eclipse is an open source platform-independent software framework, which has typi-

cally been used to develop integrated development environment (IDE). Therefore

Eclipse can be used as C/C++ IDE, if you extend it with the CDT plug-in (http://

www.eclipse.org/cdt/).

CDT means "C/C++ Development Tooling" project and is designed to use the GDB as

default debugger and works without any problems with the GDB Server.

Refer to http://www.eclipse.org for detailed information about Eclipse.

Note: We only support problems directly related to the GDB Server. Problems

and questions related to your remaining toolchain have to be solved on your own.

Other manuals for Segger J-Link