Shimadzu CBM-20A User Manual

5.12 Parameter Details
5-113
CBM-20A/20Alite
5
Baud Rate [bps]
300
600
1200
2400
4800
9600
19200
9600
Used only if the communication mode is set
to [Manual].
Protocol
No Protocol
Level 1
Level 2
Level 3
Level 2
Used only if the communication mode is set
to [Manual].
Chromatopac Setting
Enable printing on
"Injection Settings"
On, Off Off
Select to print the autosampler's injection
information to Chromatopac when analysis
starts.
Enable printing on
"Fraction Results"
On, Off Off
Select to print the fraction collector's
fractionation results to Chromatopac.
Chromatopac Channel
(PAC CH)
Ch.1
Ch.2
Ch.1&2
Ch.1
Ch.1: Analysis by channel 1.
Ch.2: Analysis by channel 2.
Ch.1&2: Analysis by both channels (in 2-
wavelength mode or with 2 detectors)
Internal Clock Setting
Set time from PC clock
Click this button to read the time from the PC
and adjust the internal clock to this time.
Date Format
YY/MM/DD
MM/DD/YY
DD/MM/YY
YY/MM/DD Select the desired date format.
System P.Max Setting (See note 1.)
Enable System P.Max
OFF
AUTO
MANUAL
AUTO
OFF: No checking for the system P.Max
value.
AUTO: System P.Max value is automatically
recognized and used for checking. (See note
2.)
MANUAL: System P.Max value specified for
[System P.Max Value] is used for checking.
System P.Max Value
MPa
kgf/cm
2
psi
bar
0.0 to 130.0
0 to 1326
0 to 19000
0 to 1300
0
0
0
0
No checking when 0 is set.
Enabled when "MANUAL" is selected for
[Enable System P.Max]. When "AUTO" is
selected, the system P.Max value
automatically recognized is displayed.
Parameter
Setting
range
Default
setting
Remark

Shimadzu CBM-20A Specifications

General

Brand	Shimadzu
Model	CBM-20A
Category	Controller
Language	English