CONTENTS
5
8012428/YWL2/3-0/2016-08 | SICK O P E R A T I N G I N S T R U C T I O N S | DUSTHUNTER T
Subject to change without notice
4.3 Sender/receiver unit and reflector...............................................................71
4.3.1 Connection to the purge air supply..............................................71
4.3.2 Fitting and connecting on the duct ..............................................71
4.4 Setting standard parameters .......................................................................73
4.4.1 Assigning the MCU to the sender/receiver unit ..........................73
4.4.2 Factory settings.............................................................................74
4.4.3 Determining the function check...................................................75
4.4.4 Setting the analog outputs parameters.......................................76
4.4.5 Setting the analog inputs parameters .........................................78
4.4.6 Setting the response time ............................................................79
4.4.7 Calibration for dust concentration measurement .......................80
4.4.8 Data backup in SOPAS ET ............................................................82
4.4.9 Starting measurement mode .......................................................83
4.5 Setting the Interface module parameters....................................................84
4.5.1 General information......................................................................84
4.5.2 Setting the Ethernet module parameters .................................85
4.6 Operating/setting parameters via the optional LC-Display.........................86
4.6.1 General information on use .........................................................86
4.6.2 Password and operating levels ....................................................86
4.6.3 Menu structure .............................................................................87
4.6.4 Configuration ................................................................................87
4.6.4.1 MCU ...........................................................................87
4.6.4.2 Sender/receiver unit.................................................90
4.6.5 Using SOPAS ET to modify display settings .................................91
5 Maintenance.............................................................................................93
5.1 General ..........................................................................................................93
5.2 Maintenance on the sender/receiver unit and reflector.............................95
5.2.1 Maintenance on the sender/receiver unit...................................95
5.2.2 Maintenance on the reflector.......................................................98
5.3 Maintenance on the purge air supply ....................................................... 101
5.3.1 Control unit MCU with integrated purge air supply .................. 102
5.3.2 Optional external purge air unit ................................................ 103
5.4 Shutdown.................................................................................................... 104
6 Troubleshooting .................................................................................... 105
6.1 General ....................................................................................................... 105
6.2 Sender/receiver unit.................................................................................. 106
6.3 MCU control unit ........................................................................................ 108
6.3.1 Malfunctions .............................................................................. 108
6.3.2 Warning and error messages in the SOPAS ET program ......... 108
6.3.3 Replacing the fuse..................................................................... 110
To Next Page
Loading...
Need help?
General
