SICK DUSTHUNTER T100

89
8012428/YWL2/3-0/2016-08| SICK O P E R A T I N G I N S T R U C T I O N S | DUSTHUNTER T
Subject to change without notice
START-UP AND PARAMETER SETTINGS 4
Setting the MCU variant
The following steps are required to set the MCU for the DUSTHUNTER T50, T100 or T200
sender/receiver unit to be connected (see “Assigning the MCU to the sender/receiver unit”,
page 73):
▸ Set the MCU to “Maintenance” mode, select the “MCU Variant” submenu and select the
type “DUSTHUNTER T”.
▸ Enter the default password and store the type with “Save” (confirm twice).
The other selection options have no significance here.