2 Safety information
2.1 General safety notes
Overview
T
his section contains general safety information about the safety laser scanner.
Further information about specific product use situations can be found in the relevant
chapters.
Product integration
DANGER
T
he product can not offer the expected protection if it is integrated incorrectly.
b
Plan the integration of the product in accordance with the machine requirements
(project planning).
b
Implement the integration of the product in accordance with the project planning.
Laser class 1M
WARNING
In
visible laser radiation
Laser class 1M
IEC 60825-1:2007 & 2014
C
omplies with 21 CFR
1040.10 and 1040.11
except for deviations
pursuant to Laser Notice
No. 50, June 2007
CAUTION
L
ASER
1M
Figure 1: Laser class 1M
T
his device complies with the following standards:
•
IEC 60825-1:2007/EN 60825-1:2007
•
IEC 60825-1:2014/EN 60825-1:2014
•
21 CFR 1040.10 and 1040.11, except for changes due to Laser Notice No. 50 of
24/06/2007
The accessible laser of the safety laser scanner is not hazardous as long as the
beam cross section is not reduced by optical instruments, such as magnifying glasses,
lenses, telescopes.
The curved part of the optics cover is the outlet for the laser radiation.
The laser marking is located on the underside of the safety laser scanner.
b
You must comply with the latest version of the applicable laser safety regulations.
CAUTION
If an
y operating or adjusting devices other than those specified in this document are
used or other methods are employed, this can lead to dangerous exposure to radiation.
b
Only use the operating or adjusting devices specified in this document.
b
Only follow the methods specified in this document.
b
Do not open the housing, except for the purposes of the installation and mainte‐
nance work specified in these operating instructions.
2 SAFETY INFORMATION
10
O P E R A T I N G I N S T R U C T I O N S | microScan3 – PROFINET 8021219/1ELL/2022-01-21 | SICK
Subject to change without notice