SICK microScan3 User Manual

19 List of figures
1. Laser class 1M............................................................................................................10
2. Device overview (
left: microScan3 – PROFINET (RJ45 / SCRJ), right: microScan3 –
PROFINET (M12))........................................................................................................13
3. Principle of time-of-flight measurement....................................................................14
4. Light pulses scan an area.......................................................................................... 15
5. Protective field, shown in red in this document........................................................18
6. Reference contour field, shown in blue-green in this document.............................18
7. Collision protection field, shown in purple in this document, with reference target,
protective field and warning field.............................................................................. 19
8. Warning field, shown in yellow or orange in this document.....................................20
9. Field set, consisting of one protective field (red) and 2 warning fields (orange and
yellow)..........................................................................................................................20
10. Monitoring case 1 with field set 1............................................................................. 21
11. Monitoring case 2 with field set 2............................................................................. 21
12. Simultaneous monitoring...........................................................................................22
13. Hazardous area protection: detection of the presence of a person in the hazard‐
ous area...................................................................................................................... 23
14. Hazardous point protection: Hand detection............................................................23
15. Access protection: detection of a person when accessing a hazardous area........24
16. Mobile hazardous area protection: detection of a person when a vehicle
approaches................................................................................................................. 24
17. Prevent crawling beneath...........................................................................................26
18. Prevent stepping over.................................................................................................27
19. Unsecured areas.........................................................................................................28
20. Mounting with deflector plates (example).................................................................29
21. Mounting in an undercut (example).......................................................................... 29
22. Mounting in vehicle paneling (example)....................................................................30
23. Overrun of the protective field in front of an opening.............................................. 31
24. Tolerance band of the contour as reference field (protective field within the pro‐
tected opening, edge of the protected opening = reference contour).................... 32
25. Stationary application with horizontal scan plane for hazardous area protection.34
26. Protection against reaching over when mounted low (dimensions in mm)............ 37
27. Protection against reaching over when mounted high (dimensions in mm).......... 37
28. Scan plane at ankle height........................................................................................ 38
29. Scan plane at calf height........................................................................................... 39
30. Distance of the protective field from the wall...........................................................40
31. Stationary application in vertical operation for hazardous point protection.......... 41
32. Stationary application in vertical operation for access protection..........................44
33. Mobile application in horizontal operation for hazardous area protection.............47
34. flat-rate supplement ZF for lack of ground clearance..............................................48
35. Minimum supplement for lack of ground clearance................................................ 49
36. Stopping distance as a function of the vehicle’s speed...........................................50
37. Recommended fitting height..................................................................................... 52
38. Recommended fitting height for inverted mounting................................................ 52
39. Permissible guide tolerance of the industrial truck................................................. 54
40. Protective field in narrow aisle...................................................................................56
41. How the restart interlock works (1): no one in protective field, machine operates
..................................................................................................................................... 64
42. How the restart interlock works (2): person detected in protective field, safety out‐
put in OFF state.......................................................................................................... 64
43. How the restart interlock works (3): person in hazardous area, no detection in pro‐
tective field, safety output still in OFF state..............................................................65
44. How the restart interlock works (4): the reset pushbutton must be pressed before
restarting the machine...............................................................................................65
19 LIS
T OF FIGURES
204
O P E R A T I N G I N S T R U C T I O N S | microScan3 – PROFINET 8021219/1ELL/2022-01-21 | SICK
Subject to change without notice

SICK microScan3 Specifications

General

Brand	SICK
Model	microScan3
Category	Scanner
Language	English