SICK microScan3 User Manual

•
micr
oScan3 Core – PROFINET
•
microScan3 Pro – PROFINET
Integration in the control
T
he safety laser scanner communicates with the machine controller as follows:
•
PROFINET PROFIsafe
Connection type
T
he safety laser scanner is available in variants with the following connection types:
•
RJ45 female connector, for push-pull male connector (copper)
•
SCRJ female connector, for push-pull male connector (optical fibers)
•
M12 female connector, 4-pin
Protective field range
T
he safety laser scanner is available in variants with the following maximum protec‐
tive field range:
•
4.0 m
•
5.5 m
•
9.0 m
Further topics
•
"V
ariant overview", page 161
3.3.2 Connections
microScan3 – PROFINET (RJ45):
•
1 x f
emale connector, M12, L-coding for voltage supply
•
2 x female connector, RJ45 for push-pull male connector for ethernet (PROFINET
PROFIsafe, data output, configuration and diagnostics)
•
1 × female connector, USB 2.0 Mini-B for configuration and diagnosis
1)
microScan3 – PROFINET (SCRJ):
•
1 x female connector, M12, L-coded for voltage supply
•
2 × female connector, SCRJ (optical fibers), for Push-Pull male connector for
Ethernet (PROFINET PROFIsafe, data output, configuration and diagnostics)
•
1 × female connector, USB 2.0 Mini-B for configuration and diagnosis
1)
microScan3 – PROFINET (M12):
•
1 x male connector, M12, A-coding for voltage supply
•
2 x female connector, M12, D-coded for Ethernet (PROFINET PROFIsafe, data
output, configuration and diagnostics)
•
1 × female connector, USB 2.0 Mini-B for configuration and diagnosis
1)
3.3.3 System plug
A system plug is required to operate the safety laser scanner.
T
he metal plate with the connections is the system plug (see figure 2, page 13). The
system plug can either be mounted on the rear side or the underside.
The safety laser scanner’s internal configuration memory is integrated in the system
plug. The system plug and all connecting cables can remain at the installation site
when the safety laser scanner is replaced. The system plug is detached from the
defective safety laser scanner and connected to the new safety laser scanner. The
new safety laser scanner reads the configuration from the configuration memory when
switching on.
1)
T
he USB connection may only be used temporarily and only for configuration and diagnostics.
3 P
RODUCT DESCRIPTION
16
O P E R A T I N G I N S T R U C T I O N S | microScan3 – PROFINET 8021219/1ELL/2022-01-21 | SICK
Subject to change without notice

SICK microScan3 Specifications

General

Brand	SICK
Model	microScan3
Category	Scanner
Language	English