SICK microScan3 User Manual

8 Commissioning
8.1 Safety
WARNING
H
azard due to lack of effectiveness of the protective device
b
Before commissioning the machine, make sure that the machine is first checked
and released by qualified safety personnel.
b
Only operate the machine with a perfectly functioning protective device.
DANGER
D
angerous state of the machine
During commissioning, the machine or the protective device may not yet behave as you
have planned.
b
Make sure that there is no-one in the hazardous area during commissioning.
DANGER
H
azard due to lack of effectiveness of the protective device
When changes are made to the machine, the effectiveness of the protective device may
be affected unintentionally.
b
After every change to the machine and changes to the integration or operational
and secondary conditions of the safety laser scanner, check the protective device
for effectiveness and recommission as specified in this chapter.
Before initial commissioning, project planning, mounting, electrical installation and
conf
iguration must be completed in accordance with the following chapters:
•
"Project planning", page 25
•
"Mounting", page 76
•
"Electrical installation", page 81
•
"Configuration", page 85
8.2 Alignment
The following options are available to you for precisely aligning the safety laser scanner
usin
g mounting kit 2:
COMMISSIONING 8
8021219/1ELL/2022-01-21 | SICK O P E R A T I N G I N S T R U C T I O N S | microScan3 – PROFINET
133
Subject to change without notice

SICK microScan3 Specifications

General

Brand	SICK
Model	microScan3
Category	Scanner
Language	English