Commissioning
5.4 Quick commissioning with a PC.
Converter with the CU240B-2 and CU240E-2 Control Units
148 Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
5. Press the "Accessible nodes" button.
Image 5-4 "Accessible nodes" in STARTER
Image 5-5 "Accessible nodes" in Startdrive
6. When the USB interface is appropriately set, then the "Accessible nodes" screen form
shows the inverters that can be accessed.
Image 5-6 Inverters found in STARTER
Image 5-7 Inverters found in Startdrive
If you have not correctly set the USB interface, then the following "No additional nodes
found" message is displayed. In this case, follow the description below.
To Next Page
Loading...
