Siemens CU240B-2 - Page 478

Appendix
A.1 New and extended functions
Converter with the CU240B-2 and CU240E-2 Control Units
478 Operating Instructions, 01/2016, FW V4.7 SP6, A5E34259001B AC
Table A- 2 New functions and function changes in firmware 4.7 SP3
Function
SINAMICS
G120
G120D
1 PM240-2 Power Modules, frame sizes FSD and FSE are sup-
ported
- - ✓ ✓ ✓ ✓ - - -
The Safety Integrated basic function Safe Torque Off (STO) is
supported via the terminals of the PM240-2 Power Module,
frame sizes FSD and FSE
- - - - ✓ ✓ - - -
2 Revised PM230 Power Module with new article numbers sup-
ported:
• IP55 degree of protection: 6SL3223-0DE . . - . .
G
.
• IP20 degree of protection and Push Through: 6SL321 . -
1NE . . - . .
G
.
You can find additional information in the "Safety Integrated"
function manual.
Overview of the manuals (Page 507)
- - ✓ ✓ ✓ - - - -
The Safety Integrated basic function Safe Torque Off (STO) is
supported with the revised PM230 Power Module
- - - - ✓ - - - -
3
PM330 Power Module, frame size HX is supported
-
-
✓
-
-
-
-
-
-
4
1FP1 reluctance motors are supported
-
-
✓
-
-
-
-
-
-
5 Encoderless 1FK7 synchronous motors are supported
1)
Operation with 1FK7 synchronous motors without encoder
has already been released with firmware V4.7 for SINAMICS
G120D with CU240D-2 Control Units.
- ✓ - ✓ ✓ ✓ ✓
1)
- -
6
Encoderless 1FG1 geared synchronous motors are supported
-
✓
-
✓
✓
✓
✓
-
-
7 Selection list for 1PH8 induction motors in the STARTER and
Startdrive commissioning wizard
- ✓ ✓ ✓ ✓ ✓ - - -
8 Updated selection list for 1LE1 induction motors in the
STARTER and Startdrive commissioning wizard
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
9 Motor support expanded with 1LE1, 1LG6, 1LA7 and 1LA9
induction motors
✓ - - - - - - - -
10 Speed and position control obtain their respective actual value
from an SSI encoder with incremental tracks. The output sig-
nals of the encoder are available as encoder 2 for position
control and timer 1 for speed control.
- - - - - ✓ - ✓ -
11
Power Module with temperature-controlled fan
✓
-
-
-
-
-
-
-
-