Siemens SIMATIC S7-1500 Motion Control V13 - Opening the Parameter View

Configuring
6.8 Parameter view
S7-1500 Motion Control V13 Update 3
Function Manual, 07/2014, A5E03879256-AC
163
Column
Explanation
Offline
Online
Data type Data type of the parameter.
The display field is empty for parameters that are not contained in the technol-
ogy data block.
X X
Retain Designates the value as a retentive value.
The values of retentive parameters are retained even after the voltage supply is
switched off.
X X
Accessible from HMI
Indicates whether the HMI can access this parameter during runtime.
X
X
Visible in HMI Indicates whether the parameter is visible in the selection list of the HMI by
default.
X X
Comment
Brief description of the parameter.
X
X
6.8.3
Opening the parameter view
Requirement
The technology object was added in the project navigator.
Procedure
1. Open the "Technology objects" folder in the project tree.
2. Open the technology object in the project tree.
3. Double-click the "Configuration" object.
4. Select the "Parameter view" tab in the top right corner.
Result
The Parameter view opens. Each displayed parameter is represented by one row in the
parameter table.
The displayable parameter properties (table columns) vary depending on whether you are
working with the Parameter view in offline or online mode.
In addition, you can selectively display and hide individual table columns.