Siemens SINAMICS G130 - Installing STARTER

Commissioning
5.2 STARTER commissioning tool
Inverter chassis units
128 Operating Instructions, 07/2016, A5E00331449A
5.2.1
Installing STARTER
STARTER is installed using the "setup" file on the customer DVD supplied. When you
double-click the "Setup" file, the installation Wizard guides you through the process of
installing STARTER.
Note
Installation time
The installation time depends on the computer performance and from where the software is
ins
talled (e.g. DVD, hard disk, network). We recommend that you install the software from a
local data carrier.
5.2.2
The STARTER user interface
STARTER features four operating areas:
Figure 5-1 STARTER operating areas