Siemens SINAMICS G130 - Basic Commissioning

Commissioning
5.5 First commissioning with the AOP30
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
173
5.5.2
Basic commissioning
Entering the motor data
During initial commissioning, you have to enter motor data using the operator panel. Use the
data shown on the motor type plate.
Figure 5-41 Example of a motor type plate
Table 5- 1 Motor data
Parameter no.
Values
Unit
System of units for line frequency and entering motor data p0100 0
1
IEC [50 Hz / kW]
NEMA [60 Hz / hp]
Motor:
Rated voltage
Rated current
Rated power
Rated power factor cos ϕ (at p0100 = 0 only)
Rated efficiency η (at p0100 = 1only)
Rated frequency
Rated speed
p0304
p0305
p0307
p0308
p0309
p0310
p0311
[V]
[A]
[kW] / [hp]
[%]
[Hz]
[min-1] / [rpm]