Siemens SINAMICS G130 - Display Areas

Functions, monitoring, and protective functions
9.2 Drive functions
Inverter chassis units
448 Operating Instructions, 07/2016, A5E00331449A
Note
Secure passwords
No password rules are defined for the assignment of passwords. You can assign any
passwords without restriction. No checks are made for illegal characters or passwords which
have already been used. Therefore, as the user, you are responsible for the requi
red
password security.
Use a sufficiently long password (e.g. 10 characters). Use special characters and avoid
passwords which you have already used elsewhere.
Please note that if the Windows language settings are changed, errors can occur when
subsequent
ly checking the password. If you use language-specific special characters, you
must ensure that the same language setting is active for subsequent entry of the password.
Configuration via AOP30 or via the expert list
Configuration is performed in parameters p8986 (web server configuration):
Bit 00:
Activate the web server (factory setting: activated)
Bit 01:
Permit access only via https (factory setting: not activated)
Bit 02:
Activate "SINAMICS" user (factory setting: enabled)
Bit 03:
Activate "Administrator" user (factory setting: not enabled)
Note
Password assignment after assignment of the user "Administrator"
After the user "Administrator" has been activated via parameter p8986 (via AOP30 or via the
expert list), it is necessary to assign a
password via STARTER. Otherwise, the user
"Administrator" will not be able to access the web server.
9.2.23.4
Display areas
The web server has different display areas, which are opened via the menu items in the
navigation.
Home
The start page of the web server is opened via this menu item.
Device Info
This menu item shows the most important device information.