Operation
6.3 Basic information about the drive system
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
197
p0120
PDS) number
p0130
Motor data sets (MDS) number
p0139[0...2]
Copy motor data set (MDS)
p0140
Encoder data sets (EDS) number
p0170
Command data set (CDS) number
p0180
Drive data set (DDS) number
p0186 [0...n]
Assigned motor data set (MDS)
p0187[0...n]
Encoder 1 encoder data set number
p0188[0...n]
Encoder 2 encoder data set number
p0189[0...n]
Encoder 3 encoder data set number
p0809[0...2]
Copy command data set CDS
p0810
BI: Command data set selection CDS bit 0
p0811
BI: Command data set selection
CDS bit 1
p0819[0...2]
p0820[0...n]
BI: Drive data set selection, bit 0
p0821[0...n]
BI: Drive data set selection, bit 1
p0822[0...n]
BI: Drive data set selection, bit 2
p0823[0...n]
BI: Drive data set selection, bit 3
p0824[0...n]
BI: Drive data set selection, bit 4
BICO technology: interconnecting signals
Description
Every drive contains a large number of interconnectable input and output variables and
internal control variables.
The drive unit can be adapted to a wide range of requirements using BICO technology
(Binector Connector Technology).
Digital signals, which can be connected freely by means of BICO parameters, are identified
by the prefix BI, BO, CI or CO in their parameter name. These parameters are identified
accordingly in the parameter list or in the function diagrams.
Note
Using STARTER
The STARTER parameterization and commissioning tool is recommended when using BICO
technology.
To Next Page
Loading...
