Siemens SINAMICS G130 - Parameters

Functions, monitoring, and protective functions
9.3 Extended functions
Inverter chassis units
462 Operating Instructions, 07/2016, A5E00331449A
9.3.2.5
Parameters
Bypass function
•
p1200
Flying restart operating mode
•
p1260
Bypass configuration
•
r1261
CO/BO: Bypass control/status word
•
p1262
Bypass dead time
•
p1263
Debypass delay time
•
p1264
Bypass delay time
•
p1265
Bypass speed threshold
•
p1266
BI: Bypass control command
•
p1267
Bypass changeover source configuration
•
p1268
BI: Bypass feedback signal synchronization completed
•
p1269
BI: Bypass switch feedback signal
•
p1274
BI: Bypass switch monitoring time
Synchronization
•
p3800
Sync
–supply–drive activation
•
p3801
Sync
–supply–drive drive object number
•
p3802
BI: Sync
–supply–drive enable
•
r3803
CO/BO: Sync
–supply–drive control word
•
r3804
CO: Sync
–supply–drive target frequency
•
r3805
CO: Sync
–supply–drive frequency difference
•
p3806
Sync
–supply–drive frequency difference threshold
•
r3808
CO: Sync
–supply–drive phase difference
•
p3809
Sync
–supply–drive phase setpoint
•
p3811
Sync
–supply–drive frequency limitation
•
r3812
CO: Sync
–supply–drive correction frequency
•
p3813
Sync
–supply–drive phase synchronism threshold
•
r3814
CO: Sync
–supply–drive voltage difference
•
p3815
Sync
–supply–drive voltage difference threshold
•
r3819
CO/BO: Sync
–supply–drive status word