Siemens SINAMICS G130 - General Information about Command and Setpoint Sources

Operation
6.2 General information about command and setpoint sources
Inverter chassis units
186 Operating Instructions, 07/2016, A5E00331449A
6.2
General information about command and setpoint sources
Description
4 default settings are available for selecting the command sources and 4 for selecting the
setpoint sources for the SINAMICS G130. The choice "no selection" is also available; if
selected, no default settings are applied for the command and setpoint sources.
Command sources
● PROFIdrive
● TM31 terminals
● CU terminals
● PROFIdrive+TM31
Setpoint sources
● PROFIdrive
● Analog inputs
● Motorized potentiometer
● Fixed setpoints
The various assignments are explained in the following sections.
Note
Default settings
Make sure that the default settings you choose during commissioning are compatible with
the system configuration (for more information, see "Commissioning")
Function diagrams
At certain points in this chapter, reference is made to function diagrams with a 4-digit
number. These are stored on the CD in the "SINAMICS G130/G150 List Manual", which
provides experienced users with detailed descriptions of all the functions.