Siemens SINAMICS G130 - Basic Information about the Drive System

Operation
6.3 Basic information about the drive system
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
187
6.3
Basic information about the drive system
6.3.1
Parameters
Overview
The drive is adapted to the relevant drive task by means of parameters. Each parameter is
identified by a unique parameter number and by specific attributes (e.g. read, write, BICO
attribute, group attribute, and so on).
The parameters can be accessed via the following means:
● PC with the "STARTER" commissioning tool via PROFIBUS or PROFINET or via
Ethernet
● The user-friendly AOP30 Operator Panel
Parameter types
The following adjustable and display parameters are available:
● Adjustable parameters (write/read)
These parameters have a direct impact on the behavior of a function.
Example: Ramp-up and ramp-down time of a ramp-function generator
● Display parameters (read-only)
These parameters are used to display internal variables.
Example: current motor current
Figure 6-1 Parameter types
All these drive parameters can be read and changed via PROFIBUS or PROFINET using the
mechanisms defined in the PROFIdrive profile.