Siemens SINAMICS G130 - Simple Brake Control

Functions, monitoring, and protective functions
9.2 Drive functions
Inverter chassis units
422 Operating Instructions, 07/2016, A5E00331449A
Parameter
•
p0010
Commissioning parameter filter
•
p0100
IEC/NEMA mot stds
•
p0349
Unit system, motor equivalent circuit diagram data
•
p0505
Unit system selection
•
p0595
Technological unit selection
•
p0596
Technological unit reference variable
•
p2000
Reference speed reference frequency
•
p2001
Reference voltage
•
p2002
Reference current
•
p2003
Reference torque
•
r2004
Reference power
•
p2005
Reference angle
•
p2006
Reference temperature
•
p2007
Reference accelera
tion
9.2.17
Simple brake control
Description
The "Simple brake control" is used exclusively for the control of holding brakes. The holding
brake is used to secure drives against unwanted motion when deactivated.
The control command for releasing and applying the holding brake is transmitted directly to
the converter via DRIVE-CLiQ from the Control Unit, which logically combines the signals
with the system-internal processes and monitors these signals.
The converter then performs the action and controls the output for the holding brake
appropriately.
The operating principle of the holding brake can be configured using parameter p1215.