Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
162 Operating Instructions, 07/2016, A5E00331449A
Transferring the drive project
You have created a project and saved it to your hard disk. You now have to transfer your
project configuration data to the drive unit.
Specifying the online access point
To connect to the target system, the chosen access point must be specified.
In the menu bar, select
>
Select target devices ...
; the following dialog screen
appears.
Figure 5-33 Target device selection and access points
The dialog screen lists all existing devices in the project.
To Next Page
Loading...
