Siemens SINAMICS G130 - Configuring the Drive Unit

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
137
5.3.2
Configuring the drive unit
In the project navigator, open the component that contains your drive unit.
Figure 5-12 Project navigator – configuring the drive unit
⇒
In the project navigator, click the plus sign next to the drive unit that you want to configure.
The plus sign becomes a minus sign and the drive unit configuration options are displayed
as a tree below the drive unit.
⇒
Double-click
Configure the drive unit
.