Operation
6.3 Basic information about the drive system
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
201
Example 2: connection of OC/OFF3 to several drives
The OFF3 signal is to be connected to two drives via terminal DI 2 on the Control Unit.
Each drive has a binector input 1. OFF3 and 2. OFF3. The two signals are processed via an
AND gate to STW1.2 (OFF3).
Figure 6-8 Connection of OFF3 to several drives (example)
Analysis of BICO interconnections
The following parameters exist for the analysis of existing BICO interconnections:
r9481
Number of BICO interconnections
r9482[0...n]
BICO interconnections BI/CI parameters
r9483[0...n]
BICO interconnections BO/CO parameters
p9494
BICO interconnections, search signal source
p9495
BICO interconnections, search signal sourc
e number
p9496
BICO interconnections, search signal source first index
BICO interconnections to other drives
The following parameters are available for BICO interconnections to other drives:
r9490
Number of BICO interconnections to other drives
r9491[0...9]
BI/CI of BICO interconnections to other drives
r9492[0...9]
BO/CO of BICO interconnections to other drives
p9493[0...9]
Reset BICO interconnections to other drives
To Next Page
Loading...
