Siemens SINAMICS G130 - Page 601

Appendix
A.2 Parameter macros
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
601
Parameter macro p1000 = 4: Fixed setpoint (100004)
This macro is used to set the fixed setpoint as the setpoint source.
Table A- 9 Parameter macro p1000 = 4: Fixed setpoint
Sink
Source
Parameters
Description
DO
Parameters
Description
DO
p1070
Main setpoint
Vector
r1024
Active fixed setpoint
Vector
p1071
Main setpoint scaling
Vector
1
100 %
Vector
p1075 Supplementary setpoint Vector 0 Vector
p1076
Supplementary setpoint scaling
Vector
1
100 %
Vector