Siemens SINAMICS G130 - Page 74

Electrical installation
4.10 Signal connections
Inverter chassis units
74 Operating Instructions, 07/2016, A5E00331449A
WARNING
Fire hazard due to overheating when permissible connection cable lengths are exceeded
Excessively long connection cables connected to terminal strip X46 can cause components
to overheat with the associated risk of fire and smoke.
• Limit the length of the connecting cables to a maximum of 10 m.
• Do not route the connection cable outside the control cabinet or control cabinet group.
X400 – X402: DRIVE-CLiQ interface
Table 4- 13 DRIVE-CLiQ interface X400 – X402: Power Module
Pin
Signal name
Technical data
1 TXP Transmit data +
2
TXN
Transmit data -
3
RXP
Receive data +
4
Reserved, do not use
-
5
Reserved, do not use
-
6
RXN
Receive data -
7
Reserved, do not use
-
8
Reserved, do not use
-
A
+ (24 V)
Power supply
B
M (0 V)
Electronics ground
Blanking plate for DRIVE-CLiQ interfaces (50 pcs.) Article number: 6SL3066-4CA00-0AA0