Siemens SINUMERIK 802D sl - Data Lists; Machine Data

Velocities, Setpoint/Actual Value Systems, Closed-Loop Control (G2)
7.5 Data lists
Turning, Milling, Nibbling
136 Function Manual, 11/2012, 6FC5397-1CP10-5BA0
7.5 Data lists
7.5.1 Machine data
Number Identifier Name
Specific to control panel
203 DISPLAY_RESOLUTION Display resolution
204 DISPLAY_RESOLUTION_INCH Display resolution for INCH system of measurement
205 DISPLAY_RESOLUTION_SPINDLE Display resolution for spindle
General information
10000 AXCONF_MACHAX_NAME_TAB[0]...[5] Machine axis name
10200 INT_INCR_PER_MM Computational resolution for linear positions
10210 INT_INCR_PER_DEG Computational resolution for angular positions
10240 SCALING_SYSTEM_IS_METRIC Basic system metric
10260 CONVERT_SCALING_SYSTEM Basic system switchover active
11240 PROFIBUS_SDB_NUMBER[0]...[3] SDB number
13060 DRIVE_TELEGRAM_TYPE[0]...[30] Standard telegram type for PROFIdrive
Channel-specific
20150 GCODE_RESET_VALUES[n] Reset G groups
Axis-specific
30110 CTRLOUT_MODULE_NR[0] Setpoint assignment: Drive number/module number (analog
spindle)
30120 CTRLOUT_NR[0] Setpoint: Output to module
30130 CTRLOUT_TYPE[0] Output type of setpoint
30134 IS_UNIPOLAR_OUTPUT[0] Setpoint output is unipolar (analog spindle)
30200 NUM_ENCS Number of encoder =1 (spindle without encoder value =0)
30220 ENC_MODULE_NR[0] Actual value: Drive module number/measuring circuit number
30230 ENC_INPUT_NR[0] Actual value: Input number on module/measuring circuit board
30240 ENC_TYPE[0] Type of actual-value acquisition (position actual value)
30300 IS_ROT_AX Rotary axis
30350 SIMU_AX_VDI_OUTPUT Output of axis signals for simulation axes
31000 ENC_IS_LINEAR[0] Direct measuring system (linear scale)
31010 ENC_GRID_POINT_DIST[0] Distance between reference marks on linear scales
31020 ENC_RESOL[0] Encoder pulses per revolution
31030 LEADSCREW_PITCH Leadscrew pitch
31040 ENC_IS_DIRECT[0] Encoder is connected directly to the machine
31050 * DRIVE_AX_RATIO_DENOM[0]...[5] Denominator load gearbox
31060 * DRIVE_AX_RATIO_NUMERA[0]...[5] Numerator load gearbox
31070 DRIVE_ENC_RATIO_DENOM[0] Measuring gearbox denominator
31080 DRIVE_ENC_RATIO_NUMERA[0] Measuring gearbox numerator
32000 MAX_AX_VELO Maximum axis velocity