Measurement (M5)
13.6 Data lists
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
259
13.6 Data lists
13.6.1 Machine data
Number Identifier Name
General
13200 MEAS_PROBE_LOW_ACTIVE Switching characteristics of probe
13.6.2 Interface signals
Number Bit Name
HMI signals (from HMI to PLC)
V1700 0003 .7 *** Measuring in JOG active
V1800 0000 .0 AUTOMATIC mode (request by HMI)
V1800 0000 .1 MDA mode (request by HMI)
V1800 0000 .2 JOG mode (request by HMI)
V1800 0000 .4 Change mode disable (request by HMI)
V1800 0000 .6**** Start measuring in JOG (request by HMI)
V1800 0001 .2 REF machine function (request by HMI)
HMI signals (from PLC to HMI)
VD1900 5004 Tool number for tool measuring in JOG (input by PLC)
General (from NCK to PLC)
V2700 0001 .0 Probe 1 is actuated
Axis/spindle-specific (from axis to PLC)
V390x 0002 .3 Measurement active
To Next Page
Loading...
