Siemens SINUMERIK 802D sl - Feedrate Control; Overview; Feedrate Disable and Feedrate;Spindle Stop

Feed (V1)
24.3 Feedrate control
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
417
24.3 Feedrate control
24.3.1 Overview
;D[LVUDGLXV
3DWKYHORFLW\
*
,65DSLGWUDYHUVHRYHUULGHDFWLYH
,6)HHGUDWHRYHUULGHDFWLYH
,62YHUULGHDFWLYH
,6$FWLYDWHGU\UXQIHHGUDWH
,6$FWLYDWHGU\UXQ
IHHGUDWH
6''5<B581B)(('
GU\UXQ
IHHGUDWH





3/&
*
6DYHG
6YDOXH
6SLQGOHVSHHGVHWSRLQW
6SLQGOHRYHUULGH
IURPPDFKLQH
FRQWUROSDQHO
6*
3;
*
*
3URJU6YDOXH
***
*
*
3/&
3URJU)YDOXH
0D[L
PXPb
)YDOXH
*
)HHGRYHUULGH
IURPPDFKLQHFRQWURO
SDQHO[[[
Figure 24-1 Possibilities for programming and controlling the feedrate
24.3.2 Feedrate disable and feedrate/spindle stop
General
The "Feed disable" or "Feed/spindle stop" brings the axes to a standstill. The path contour is
maintained (exception: G33 block).
Feed disable
The channel-specific interface signal "Feed disable" (V3200 0006.0) will stop all axes
(geometry and special axes) in all operating modes.
This feed disable is not effective if G33 is active; it is, however, active with G63, G331,
G332.