Siemens SINUMERIK 802D sl - Coupling Diagram

Speed/torque coupling, master-slave (TE3)
23.2 Coupling diagram
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
393
23.2 Coupling diagram
If the coupling is closed, the slave axis is traversed only with the load-side setpoint speed of
the master axis. It is therefore only speed-controlled, not position-controlled.
No positional deviation control is implemented between master and slave axes. A torque
compensatory controller divides the torque evenly over the master and slave axes.
An additional torque can be used to achieve a tension between the master and slave axis.
If different motors are used, individual weighting factors can be used to adapt the torque
distribution.
(
3RVLWLRQ
VHW
6/$9(
0$67(5
:HLJKWLQJ
'ULYH3RVLWLRQFRQWUROOHU
6HUYRWUDFH
7RUTXHFRPSHQVDWLRQ
FRQWUROOHU
6HUYRWUDFH7HQVLRQWRUTXH
Q
VHW 
7RUTXHFRQWUROOHU6SHHGFRQWUROOHU
6SHHGFRQWUROOHU

,
0
0

Q
DFW
L
VHW
Q
VHW
3RVLWLRQ
DFW
3RVLWLRQ
VHW
L
DFW
:HLJKWLQJ
0HFKDQLFDO
FRXSOLQJ
7RUTXHFRQWUROOHU



,QWHUFRQQHFWLRQ
&RQWUROOHU
RXWSXW
37ILOWHU

3,
FRQWUROOHU


7HQVLRQWRUTXH

6SHHGVHWSRLQWFRXSOLQJ
L
VHW
3RVLWLRQ
DFW
3RVLWLRQFRQWUROOHU
3RVLWLRQFRQWUROOHU
,QWHU
SRODWRU
Q
DFW
L
DFW
Figure 23-3 Control structure