Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
265
Punching and Nibbling (N4)
15
Note
This function is only available for the G/N plus and pro versions.
15.1 Brief Description
Subfunctions
The functions specific to punching and nibbling operations comprise the following:
● Stroke control
● Automatic path segmentation
● Rotatable punch and die
● Clamp protection
They are activated and deactivated via language commands.
15.2 Stroke control
15.2.1 General information
Functionality
The stroke control is used in the actual machining of the workpiece. The punch is activated
via an NC output signal when the position is reached. The punching unit acknowledges its
punching motion with an input signal to the NC. No axis may move within this time period.
Repositioning takes place after the punching operation.
High-speed signals
"High-speed signals" are used for direct communication between the NC and punching unit.
Combined with the punch, they allow a large number of holes to be punched per minute
since the punch positioning times are interpreted as machining delays.
To Next Page
Loading...
Need help?
General
