Siemens SINUMERIK 802D sl - Interface Signals

Feed (V1)
24.4 Data lists
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
421
Number Identifier Name
42010 THREAD_RAMP_DISP Acceleration behavior of the feedrate axis when
thread cutting
42110 DEFAULT_FEED Default value for path feed
24.4.2 Interface signals
Number Bit Name
Channel-specific
V3200 0000 .6 Activate dry run feed
V3200 0004 - Feed override
V3200 0005 Rapid traverse override
V3200 0006 .0 Feed disable
V3200 0006 .6 Rapid traverse override active
V3200 0006 .7 Feed rate override active
V32001000 .3 Feed stop, geometry axis 1
V32001004 .3 Feed stop, geometry axis 2
V32001008 .3 Feed stop, geometry axis 3
V1700 0000 .6 Dry run feed rate selected
V1700 0001 .3 Feed rate override selected for rapid traverse
V3300 0001 .2 Revolutional feed rate active
Axis/spindle-specific
VB380x 0000 - Feed override
VB380x 2003 - Spindle override
V380x 0001 .7 Override active (axis or spindle)
V380x 2001 .0 Feedrate override for spindle valid
V380x 0004 .3 Feed stop/spindle stop
V390x 2002 .0 Constant cutting rate active (spindle)
V390x 2002 .3 Tapping without compensation chuck active (spindle)