Siemens SINUMERIK 802D sl Function Manual

Kinematic Transformation (M1)
12.4 Special features of TRANSMIT and TRACYL
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
247
12.4 Special features of TRANSMIT and TRACYL
POWER ON/RESET
The system response after POWER ON or RESET (program end) is determined by the
settings stored in the following machine data:
● MD20110 RESET_MODE_MASK (access to this MD only in protection level 1/1)
● MD20140 TRAFO_RESET_VALUE (active transformation after RESET).
Please note on selection
● Tool radius compensation must be deselected (G40).
● The frame which was active prior to TRANSMIT / TRACYL is deselected by the control.
(G500).
● The control deselects an active working area limit for axes affected by the transformation
(WALIMOF).
● Continuous path control and rounding are interrupted.
● An instructed intermediate movement block with chamfer or radius is not inserted.
Please note on deselection
● Tool radius compensation must be deselected (G40).
● Continuous path control and rounding are interrupted.
● An instructed intermediate movement block with chamfer or radius is not inserted.
● Following TRANSMIT / TRACYL deselection, zero offsets (Frame) and all settings used
for the turning operation are to be reset.
Operating modes, operating mode changeover
● The program processing with TRANSMIT/ TRACYL is performed in AUTOMATIC.
● It is possible to interrupt the AUTOMATIC operation and change over to JOG. When
returning to AUTOMATIC mode, the operator must ensure a problem-free repositioning of
the tool.
● Axes cannot be referenced when a transformation is active.

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English