Siemens SINUMERIK 802D sl Function Manual

Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
423
Tool: Compensation and Monitoring (W1)
25
25.1 Tool and tool compensation overview
Characteristics
The SINUMERIK 802D sl control is capable of calculating the tool compensation data for
different tool types (drill, milling cutter, turning tool, ...).
● Length compensation
● Radius compensation
● Storage of the tool compensation data in the tool offset memory
– Tool identification with T numbers from 0 to 32000
– Definition of a tool with a maximum of nine cutting edges (offset blocks) through D
number
– Cutting edge is described by tool parameters:
Tool type
Geometry: Length/radius
Wear: Length/radius
Cutting edge position (for turning tools)
● Tool change selectable: Immediately with T command or through M6
● Tool radius compensation
– Compensation active for all interpolation types: linear and circular
– Compensation at outer corners selectable: transition circle (G450) or equidistant
intersection (G451)
– Automatic detection of outer/inner corners
Detailed description:
References:
/BP_/ Operation and Programming

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English