Siemens SINUMERIK 802D sl Function Manual

Operating Modes, Program Operation (K1)
10.4 Program test
Turning, Milling, Nibbling
198 Function Manual, 11/2012, 6FC5397-1CP10-5BA0
This function is activated via IS "Activate skip block" (V3200 0002.0).
Display
The checkback signal that the "Skip block" function is active is displayed in the relevant
"SKP" status line on the user interface.
10.4.7 Graphic simulation
Function
In the AUTOMATIC operating mode a selected and opened program can be simulated
graphically on the screen of the control unit. The movements of the programmed axes are
recorded as line diagram after an "NC Start".
Selection/deselection
The graphic simulation can be reached for the selected program through the "Program"
operating area, open program and "Simulation" softkey. Here the IS "Simulation active"
(V1900 0000.6) is set and reset again on leaving the "Program" operating area or changing
to "Edit".
Display
Due to numerous operating possibilities a complete workpiece, or else only enlarged details
of it, can be displayed on the screen.
References:
/BP_/ Operation and Programming
PLC user program
The PLC user program must itself influence the required behavior of the control system in
simulation, for example:
● Stop axes/spindle by transition into the program test: Set IS "Activate program test"
(V3200 0001.7)
● Abort the running program if "Simulation" is exited by setting IS "Reset" (V3000 000.7),
etc.
Display machine data
A number of display machine data (MD283 to MD292) is available for the user-specific
configuration of the graphic simulation.
References:
/LIS/ SINUMERIK 802D sl lists

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English