Siemens SINUMERIK 802D sl - Data Lists; Machine Data; Setting Data; Interface Signals

Travel to fixed stop (F1)
5.6 Data lists
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
83
5.6 Data lists
5.6.1 Machine data
Number Identifier Name
Axis-specific
37000 FIXED_STOP_MODE Travel to fixed stop mode
37002 FIXED_STOP_CONTROL Special function when traveling to fixed stop
37010 FIXED_STOP_TORQUE_DEF Default for clamping torque
37012 FIXED_STOP_TORQUE_RAMP_TIME Virtual time until reaching the new clamping
torque when traveling to fixed stop
37020 FIXED_STOP_WINDOW_DEF Default for fixed stop monitoring window
37030 FIXED_STOP_THRESHOLD Threshold for fixed stop detection
37040 FIXED_STOP_BY_SENSOR Fixed stop detection via sensor
37050 FIXED_STOP_ALARM_MASK Enabling the fixed stop alarms
37060 FIXED_STOP_ACKN_MASK Monitoring of PLC acknowledgments for travel
to fixed stop
5.6.2 Setting data
Number Identifier Name
Axis-specific
43500 FIXED_STOP_SWITCH Selection of travel to fixed stop
43510 FIXED_STOP_WINDOW Fixed stop monitoring window
43520 FIXED_STOP_TORQUE Clamping torque when traveling to fixed stop
5.6.3 Interface signals
Number Bit Name
Axis/spindle-specific
V380x 0001 .1 Acknowledge fixed stop reached
V380x 0001 .2 Sensor for fixed stop
V380x 0001 .3 Axis/spindle disable
V380x 0002 .1 Controller enable
V380x 0003 .1 Enable travel to fixed stop
V390x 0002 .4 Enable travel to fixed endstop
V390x 0002 .5 Fixed stop reached