Operating Modes, Program Operation (K1)
10.3 Processing a part program
Turning, Milling, Nibbling
174 Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Required signal states
The selected part program can now be enabled for processing with the START command.
The following enable signals are relevant:
IS "802 Ready" (V3100 0000.3) must be set
IS "Activate program test" (V3200 0001.7) may not be set
IS "NC Start disable" (V3200 0007.0) may not be set
IS "NC Stop at block limit" (V3200 0007.2) may not be set
IS "NC stop" (V3200 0007.3) may not be set
IS "NC Stop axes plus spindle" (V3200 0007.4) may not be set
IS "EMERGENCY STOP" (V2700 0000.1) may not be set
Axis or NCK alarm may not be present
Execution of command
The part program or part program block is automatically processed and IS "Channel status
active" (V3300 0003.5) and IS "Program status running" (V3300 0003.0) are set.
The program is processed until the end of the program has been reached or the channel is
interrupted or aborted by a STOP or RESET command.
Interrupts
The START command is not effective if the prerequisite is not fulfilled. Then one of the
following interrupts occurs: 10200, 10202, 10203
10.3.3 Part program interruption
Channel status
The STOP command is executed only if the channel concerned is in the "Channel active"
status (V3300 0003.5).
STOP commands
There are various commands which stop processing of the program and set the channel
status to "interrupted":
● IS "NC Stop at block limit" (V3200 0007.2)
● IS "NC stop" (V3200 0007.3)
● IS "NC Stop axes plus spindle" (V3200 0007.4)
● IS "Single block" (V3200 0000.4)
● Programming command "M0" or "M1" and corresponding activation
To Next Page
Loading...
Need help?
General
