Compensation (K3)
11.3 Interpolatory compensation
Turning, Milling, Nibbling
Function Manual, 11/2012, 6FC5397-1CP10-5BA0
219
Complex compensation
Since it is possible to use the position of an axis as the input quantity (base axis) for several
tables, to derive the total compensation value of an axis from several compensation
relationships (tables) and to multiply tables, it is also possible to implement sophisticated and
complex beam sag and angularity error compensation systems.
This function also makes it possible to deal with different error sources efficiently. For
example, it is possible to combine a table with a modulo function for a periodic recurring
error component with a second table without a modulo function for an aperiodic error
component for the same axis.
Leadscrew errors can also be compensated with this function by parameterizing an identical
axis for the base and compensation axes. Unlike with LEC, however, measuring-system
switchovers are not automatically registered in this case.
Activation
The "sag compensation" function does not become active until the following conditions are
fulfilled:
● The option "Sag compensation, multidimensional" has been enabled.
● The function has been activated for the relevant machine axis (compensation axis):
MD32710 CEC_ENABLE [AXi] = 1
● The compensation values have been stored in the non-volatile NC user memory and are
active (after power ON).
● Evaluation of the relevant compensation table has been enabled:
SD41300 CEC_TABLE _ENABLE [t] = 1
● The current measuring system of the base and compensation axes has been referenced:
V390x 0000.4 = 1 (referenced/synchronized 1)
As soon as these conditions have been fulfilled the setpoint position of the compensation
axis is altered in all modes with reference to the setpoint position of the base axis and the
corresponding compensation value and is then immediately traversed by the machine axis.
If the reference is then lost, e.g. because the encoder frequency has been exceeded (V390x
0000.4 = 0), compensation processing is deactivated.
Compensation interpolation points
The number of required interpolation points in the compensation table must be defined for a
compensation relationship: With 802D sl, 2 tables with 350 interpolation points each are
provided.
To Next Page
Loading...
Need help?
General
