Feed (V1)
24.1 Path feedrate F
Turning, Milling, Nibbling
410 Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Maximum tool path velocity
The maximum path velocity is obtained from the maximum velocities of the relevant axes
(MD32000 MAX_AX_VELO) and their proportion of the path. The maximum velocity of an
axis stored in the machine data cannot be exceeded.
CFC feedrate override for circles
When machining circular contours using milling tools and the active tool radius
compensation (G41/G42), the feedrate at the milling cutter center must be adjusted if the
programmed F value is intended to be active at the circular contour. If the CFC feedrate
override is active, inside and outside circle machining is detected automatically.
The feedrate override can be switched-off using CFTCP.
Reference:
/BP_/ Operation and Programming
Interface signals
If the revolutional feedrate is active, IS "Revolutional feedrate" (V3300 0001.2) is set.
If the G96/G332 function is active, the IS "Constant cutting rate active" (V390x 2002.0) is set
for the spindle.
Alarms
● If no F word is programmed at G1, G2, G3, ..., alarm 10860 is issued. An axis movement
is not possible. However, please note: SD42110 DEFAULT_FEED!
● If F0 is programmed, alarm 14800 is issued.
● If G95 is active and the spindle is stationary, an axis movement is not possible. No alarm
is issued.
Notes
● If the "Dry run feedrate" function is activated and the program is started, the feedrates
programmed in combination with G1, G2, G3, CIP, CT are replaced by the feedrate value
stored in SD42100 DRY_RUN_FEED, see Section "Program processing with dry run
feedrate (DRY)(K1)".
● The velocity of the traversing movement of an axis in the JOG mode is determined by the
machine data/setting data. Please refer to Chapter "Manual and Handwheel Travel (H1)"
for a detailed description of the velocities, including the possible "Rapid traverse
override".
To Next Page
Loading...
Need help?
General
