Commissioning Manual
6FC5397-4EP10-0BA8, 07/2018
31
MOTION-CONNECT 300 absolute
encoder cable
The MOTION-CONNECT 300 cables, MOTION-CONNECT 500 cables, and spindle setpoint cables given above are
suitable for use in drag chains. For more information on how to lay cables properly in drag chains, see Section "
the laying of cables in drag chains (Page 72)".
No additional MOTION-CONNECT 300 power cables are available for 1PH1 motors. The 30 m MOTION-
power cables (raw cables) listed above could be selected for using with 1PH1 motors. You must assemble the power
cable with connectors by yourself. For more information about how to assemble the power cable, see Section
"Assembling the power cable for the 1PH1 motor (Page 456)".
Recommended connectors for 1PH1 motor power cables
Cross-
section
Supplier Article
number
Picture Quantity
(pieces)
Used for Sup-
plier
Article
number
Picture Quantity
(pieces)
Used for
4 × 2.5 mm
2
KST RNYL 2-5
3 U/V/W KST SNYL2-
4
3 U/V/W
KST RNYL 2-6
1 PE KST RNYL 2-
5
1 PE
- - - - - IDEAL 6204
1 Cable
shielding
4 × 4 mm
2
KST RNYL 5-5
3 U/V/W KST SNYL5-
5
3 U/V/W
KST RNY 5-6
1 PE KST RNY 5-5
1 PE
- - - - - IDEAL 6204
1 Cable
shielding
4 × 10 mm
2
KST TLK 10-5
3 U/V/W KST TLK 10-
5
4 U/V/W/PE
KST TLK 10-6
1 PE - - - - -
- - - - - IDEAL 62P08
1 Cable
shielding
4 × 16 mm
2
KST TLK 16-5
3 U/V/W KST TLK 16-
5
4 U/V/W/PE
KST TLK 16-6
1 PE - - - - -
- - - - - IDEAL 62P08
1 Cable
shielding
To Next Page
Loading...
Need help?
General
