Operator control
7.2 Passwords
Modular Safety System 3RK3
System Manual, 10/2008, 926 2530-02 DS 02
211
Note
If you change the passwords, this has no effect on the release status of a configuration.
Deactivate password protection (only password for project access and password for device access)
You can deactivate the password protection again by entering a blank password. To do this,
you must first enter the old password. The fields "New password" and "Confirm password"
must remain empty.
Forgot password
● The password for project access can be reset.
● Neither of the passwords (the password for device access and the password for changing
to test mode) can be reset (factory settings necessary).
Dialog box "Edit" > "Password for project access"
● This password prompt appears in the "Enter password" dialog box when you open an
offline configuration.
● If you have still not assigned a password for project access, enter a new password at the
prompt "New password" and enter it again to "Confirm password".
● Change the project access password by entering the old password and then entering the
new password twice
● Deactivate the password protection for the project by first entering the old password and
then entering a blank password twice.
● Use the "Forgot password" button to create an activation code for when you lose the
project access password.
Dialog box "Edit" > "Password for device access"
● This password is requested in the case of password-protected write device access (e.g.
loading new configuration) or when going online (only in the case of protection level
"Project write/read protection").
● You can assign/change/reset the password for device access.
● You can set the protection level with this menu command.
Note
If you have forgotten the password for device access, you must restore the factory
settings of the MSS. You must do this on the safety relay because commands in MSS ES
are password-protected.
To Next Page
Loading...
